What I don't understand is the 'Connect the ALC feedback from the amp to pin 6 of the REMOTE.' I'm assuming it's just the ground, aka the other wire ?Ĭan I hook this amp to my IC 7000 as well? Looks like I'd have to make a breakout box īut the Swan only has the remote trigger wire. Therefore, in the 'REMOTE' connector jack on the Kenwood, I would connect it to pin 5 for N.O. Icom IC-V200 Service Manual covers following topics: How to repair Icom IC-V200 VHF FM Transceiver Service Manual Icom Ic V200 Related Entry with Service. It looks like from the Swam schematic that it is a N.O. To connect this amp to a Kenwood 820s I've read in the manual, that it can run either a N.C. Is this just an inherent problem with the old school prints (even though it's pretty clean) or am I reading one of the two things incorrectly?
And the wire that goes to the BYPASS-TUNE/CW-SSB switch stays there. And reverse them.'īut looking at the schematic they show, it looks like they cut the wire from the 12v source and connect it direct to ground. Don't hate.Īccording to the manual, you simply 'Locate the terminal strip with the black and red wires from the control cable. I picked up a Kenwood 820S and a Swan 1200x for a song.Īnyway, just for reference it has the 8950 tubes. The other weekend I was cruising Craigslist and the son of an SK was selling some equipment. Hello everyone hope you're all doing well!
